Note:

• The full product specifications below are from the manufacturer and may contain information related to other package quantities that will not apply to the product that you are reviewing. Please confirm the actual content and/or package quantity from the main product specifications page.
• These specifications may represent the entire product series/model/line to which this product belongs with specific configuration differences between the individual products stated.
• These specifications may have been copied from the same product in other region/country in which case there might be minor differences in region-specific data such as Input Voltage, Terms of Warranty etc.

General Info RoHS: Y

OUTPUT
Output Volt Amp Capacity (VA): 750
Output Watt Capacity (Watts): 600
Power Factor: 0.8
Nominal Output Voltage(s) Supported: 120V
Frequency Compatibility: 60 Hz
Output Voltage Regulation (Line Mode): -21%, +8%
Output Voltage Regulation (Battery Mode): +/- 5%
Output Receptacles: (6) 5-15R
Load Management Receptacles: Two switchable single-outlet 5-15R load banks
Output AC Waveform (AC Mode): Sine wave
Output AC Waveform (Battery Mode): Pure Sine wave

INPUT
Rated input current (Maximum Load): 7A
Nominal Input Voltage(s) Supported: 120V AC
UPS Input Connection Type: 5-15P
Input Circuit Breakers: 15A
Recommended Electrical Service: 15A 120V
Input Cord Length (ft.): 10
Input Cord Length (m): 3
Input Phase: Single-Phase

BATTERY
Full Load Runtime (min.): 4.9 min. (600w)
Half Load Runtime (min.): 13.2 min. (300w)
DC System Voltage (VDC): 24
Battery Recharge Rate (Included Batteries): Less than 4 hours from 10% to 90% (typical, full load discharge)
Internal UPS Replacement Battery Cartridge: RBC64-1U
Battery Access: Front panel battery access door
Battery Replacement Description: Hot-swappable, user replaceable batteries

VOLTAGE REGULATION
Voltage Regulation Description: Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 83 to 147
Overvoltage Correction: Input voltages between 128 and 147 are reduced by 12%
Undervoltage Correction: Input voltages between 83 and 107 are boosted by 14%

USER INTERFACE, ALERTS & CONTROLS
Switches: 2 Switches control off/on power status and alarm-cancel/self-test operation
Alarm Cancel Operation: Power-fail alarm can be silenced using alarm-cancel switch; once silenced, alarm will re-sound to indicate low-battery status
Audible Alarm: Audible alarm indicates power-failure, overload and low-battery conditions
LED Indicators: 5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status

SURGE / NOISE SUPPRESSION
UPS AC Suppression Joule Rating: 450 joules
UPS AC Suppression Response Time: Instantaneous
EMI / RFI AC Noise Suppression: Yes

PHYSICAL
Included Mounting Accessory Description: Included mounting brackets support 2 and 4 post rackmount installation; Optional 4POSTRAILKIT1U is available for additional support in 4 post rackmount applications
Primary Form Factor: Rackmount
UPS Power Module Dimensions (hwd, in.): 1.7 x 17.5 x 16.8
UPS Power Module Dimensions (hwd, cm): 4.4 x 44.4 x 42.5
Rack Height (U Spaces): 1
UPS Power Module Weight (lbs.): 30
UPS Power Module Weight (kg): 13.6
UPS Shipping Dimensions (hwd / in.): 6.2 x 23.5 x 22.5
UPS Shipping Dimensions (hwd / cm): 15.9 x 59.7 x 57.2
Shipping Weight (lbs.): 34
Shipping Weight (kg): 15.4
Cooling Method: Fan
UPS Housing Material: Steel

ENVIRONMENTAL
Operating Temperature Range: +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature Range: +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity: 0 to 95%, non-condensing
AC Mode BTU / Hr. (Full Load): 39
AC Mode Efficiency Rating (100% Load): 99%

COMMUNICATIONS
Communications Interface: DB9 Serial; EPO (emergency power off); Pre-installed network card; USB
Network Monitoring Port Description: Includes PRE-INSTALLED SNMPWEBCARD; Supports detailed monitoring of UPS and site power conditions
PowerAlert Software: Included
Communications Cable: USB and DB9 cabling included
WatchDog Compatibility: Supports Watchdog application, OS and hard-reboot restart options for remote applications

LINE / BATTERY TRANSFER
Transfer Time: 5 milliseconds AC to DC; 1 millisecond DC to AC
Low Voltage Transfer to Battery Power (Setpoint): 83
High Voltage Transfer to Battery Power (Setpoint): 147

SPECIAL FEATURES
Grounding Lug: Back panel grounding lug
Cold Start (Startup in Battery Mode During a Power Failure): Cold-start operation supported
High Availability UPS Features: Hot swappable batteries
Green Energy-Saving Features: Individually controllable load banks

CERTIFICATIONS
UPS Certifications: Tested to UL1778 (USA); Tested to CSA (Canada); Tested to NOM (Mexico); Meets FCC Part 15 Category A (EMI)